An AGV stops mid-aisle because a load wheel bearing has seized. The vehicle is carrying a 1,200 kg pallet, an...
Planting windows do not wait for maintenance. When a row-unit seeder starts dragging halfway across a field, ...
A 25 mm shaft that measures 24.990 mm, dropped into a housing bore that measures 25.020 mm, leaves a gap of 0...
An H7 hole and a p6 shaft at a 25 mm nominal size give you between 1 and 35 microns of interference. That sin...
A 15 kW motor running at 6,000 rpm should not be destroying lip seals every eight months. When it does, the s...
A conveyor drive at a foundry ran for eight months before the bearings failed. The original setup used rubber...
An inspector mics a 30 mm shaft at 30.018 mm. The drawing calls for 30 mm nominal, and the question on the be...
A dry seal on a 6205-2RS bearing pulled from a gearbox is a familiar sight on the maintenance bench. The inst...
A bore called out as 25 H7 must measure between 25.000 mm and 25.021 mm. A hole that comes off the machine at...
A 40 mm journal comes off the grinder at 39.982 mm and the operator calls it good, because it is only 0.018 m...
A maintenance team presses a 6205 bearing onto a shaft that was rebuilt by welding and hand turning. The bear...
A gearbox bearing that fails after nine months is rarely the result of bad arithmetic. Bearing life calculati...
+86-574-63269198
+86-574-63261058
+86-574-63269198
+86-574-63261058
Henghe lndustrial Zone Ningbo, Zhejiang, China.
Please leave your email address, So that we can get in touch with you as soon as possible.
Copyright © Ningbo Wanshun Bearing Co., Ltd. All Rights Reserved. Custom Ball Bearing Manufacturer
English
中文简体
Deutsch
Español